Nano Archive

Pool boiling characteristics of nano-fluids

Das , S. K. and Putra , N. and Roetzel , W. (2003) Pool boiling characteristics of nano-fluids. International Journal of Heat and Mass Transfer , 46 ( 5). pp. 851-862.

Full text is not hosted in this archive but may be available via the Official URL, or by requesting a copy from the corresponding author.

Official URL: http://www.ingentaconnect.com/content/els/00179310...

Abstract

Common fluids with particles of the order of nanometers in size are termed as 'nano-fluids' which have created considerable interest in recent times for their improved heat transfer capabilities. With very small volume fraction of such particles the thermal conductivity and convective heat transfer capability of these suspensions are significantly enhanced without the problems encountered in common slurries such as clogging, erosion, sedimentation and increase in pressure drop. This naturally brings out the question whether such fluids can be used for two phase applications or in other words phase change in such suspensions will be assistant or detrimental to the process of heat transfer. The present paper investigates into this question through experimental study of pool boiling in water-Al2O3 nano-fluids. The results indicate that the nano-particles have pronounced and significant influence on the boiling process deteriorating the boiling characteristics of the fluid. It has been observed that with increasing particle concentration, the degradation in boiling performance takes place which increases the heating surface temperature. This indicates that the role of transient conduction in pool boiling is overshadowed by some other effect. Since the particles under consideration are one to two orders of magnitude smaller than the surface roughness it was concluded that the change of surface characteristics during boiling due to trapped particles on the surface is the cause for the shift of the boiling characteristics in the negative direction. The results serve as a guidance for the design of cooling systems with nano-fluids where an overheating may occur if saturation temperature is attained. It also indicates the possibility of such engineered fluids to be used in material processing or heat treatment applications where a higher pre-assigned surface temperature is required to be maintained without changing the fluid temperature.

Item Type:Article
Subjects:Physical Science > Nanophysics
Physical Science > Nano objects
Material Science > Nanochemistry
Material Science > Nanostructured materials
Divisions:Faculty of Engineering, Science and Mathematics > School of Physics
Faculty of Engineering, Science and Mathematics > School of Chemistry
ID Code:5619
Deposited By:JNCASR
Deposited On:11 Aug 2009 07:20
Last Modified:11 Aug 2009 07:20

Repository Staff Only: item control page