Nano Archive

A 2826 MB Metglas ribbon as a strain sensor for remote and dynamic mechanical measurements

Kouzoudis, Dimitrios and Mouzakis, Dionysios E. (2006) A 2826 MB Metglas ribbon as a strain sensor for remote and dynamic mechanical measurements. Sensors and Actuators A: Physical, 127 (2). 355 - 359.

Full text is not hosted in this archive but may be available via the Official URL, or by requesting a copy from the corresponding author.

Official URL: http://www.sciencedirect.com/science/article/B6THG...

Abstract

A 2826 Metglas magnetoelastic ribbon was used as a sensor for remote, dynamic, and passive strain measurements, using a detection coil. The ribbon was attached to an epoxy resin slab and the system was dynamically loaded by a dynamic mechanical analysis (DMA) system at various loading frequencies. There was a strong correlation between the DMA data and the voltage data from the detection coil. Displacements, as low as 20 μm were easily detected and the gauge factor, which increased with the DMA frequency, was found equal to 11,700 at the 150 Hz frequency.

Item Type:Article
Additional Information:MEMS 2005 Special Issue - Special Issue of the Micromechanics Section of Sensors and Actuators (SAMM), based on contributions revised from the technical digest of the IEEE 18th International Conference on Micro Electro Mechanical Systems (MEMS-2005).
Uncontrolled Keywords:Strain sensor; Strain measurements; Metglas; DMA; Magnetoelastic; Magnetostrictive
Subjects:Analytical Science > Nanotechnology for sensing and actuating
ID Code:4736
Deposited By:SPI
Deposited On:30 Jun 2009 14:57
Last Modified:30 Jun 2009 14:57

Repository Staff Only: item control page